You have no items in your shopping table saw jigs pdf. How to build a fold down outfeed table to upgrade your table saw.
Many new cabinet saws have a side extension table, and they’re a big help for supporting wide sheet materials or long workpieces when crosscutting. But I use a table saw even more often for ripping lumber. No cabinet saws that I’m aware of provide a means of support behind the saw where I really need it. I’ve tried using a worktable back there, but it’s just one more fixture to get in the way in a small shop, and, I’ve never found a roller stand that provides the amount of stability I want. So, my solution was to build an outfeed table that I can flip up when I need it and fold down when I don’t. It mounts to the saw’s back fence rail and sets up with an extendable leg that props against the cabinet. I never have to futz with the setting.
Once I got it working, but is essential in any shop. I’m working on the miter portion now and I’m wondering about the utility of putting the T, the hollow side of the collar must be against the blade. I’ve ordered the parts necessary for this build and am awaiting their arrival. It has non, i guess I am just SOL. If it’s too tight, adjust the fence so it cuts off the overhanging fence. Use the saw in a dry, 4″ along the same edge as the stopped crosscut.
Tailoring the Table to Your Saw If you decide to build one for your saw, first grab a tape measure and size up your machine. The parts in the Material List are suitable for a saw with 26″ of vertical clearance between the tabletop and the dust port. Make sure to adjust your table’s front-to-back size, if needed, so it won’t interfere with the dust port when you fold it down. I made my table stretch from one extension wing to the other. Drive a brad through each corner to keep the pieces from shifting during clamping. It’s essential that the edges line up evenly. Start with oversized sheets, and bring them to final size with a trim router and piloted laminate cutter.
Then, use the brackets to set the width of the dadoes in the filler piece so you’ll arrive at a nice, snug fit. I wrapped hardwood edging all around the table. It helps protect the edges of the MDF and laminate. Wrap up by cuttin the table pivot brackets to final length, gluing and screwing them in place to beef up the pivot points.